Drill A Hole In The Wall - Zibro SM 18 113 Installationshandbuch

instal_SM18113.qxd
1. Fit the Installation Plate
1. Fit the installation plate
tion plate.
2. If the wall is made of brick, concrete or the like, drill eight (8) 5mm diameter holes in the wall. Insert
Clip anchor
3. Fit the installation plate
90
815
40
270~370
659 133
878

2. Drill a hole in the wall

1. Determine hole positions according to the diagram detailed in Fig.6. drill one (1) hole ( 65mm) slanting
slightly downwards to outdoor side, this will prevent water to come indoors.
2. Always use wall hole conduit when drilling metal grid, metal plate or the like.
4
56
29-02-2008 09:04 Pagina 56
horizontally on structural parts of the wall with spaces around the installa-
for appropriate mounting screws
on the wall with eight (8) type "A" screws
NOTE
Fit the Installation Plate and drill holes in the wall according to the wall structure and
corresponding mounting points on the installation plate. (Dimensions are in "mm" unless
otherwise stated)
Indoor unit outline
Over 12 cm from the wall
70
Left rear side refrigerant
pipe hole Ø65
Indoor unit outline
Over 12 cm from the wall
Left rear side refrigerant
pipe hole Ø65
Indoor
.
150 mm or more to ceiling
70
750
< 3,5 kW
150 mm or more to ceiling
920
50
≥ 3,5 kW
Wall
Outdoor
≥5°
Fig. 6
.
Installation plate
Over 12 cm
from the wall
Right rear side
refrigerant pipe
hole Ø65
Installation plate
Over 12 cm
from the wall
Right rear side
refrigerant pipe
hole Ø65
Fig. 5