Scope Of Delivery; General Advice And Safety Regulations - Calex FL - Si-Series Bedienungsanleitung

FL - Si/ GAi-Series
1.4

Scope of delivery

► Calex FL - Si -or GAi-type with LVO 25 or LVO 35
► Fibre optics cable 1.5 m, blue, stainless steel sheathing
► Inspection sheet
► User manual
► Supply in a box (without connection cable)
2

General advice and safety regulations

Intended usage
This device is only for non-contact temperature measurement. If you use the pyrometer not
compliant to the description in this user manual it may cause loss of all guarantee claims against
the manufacturer.
General source of danger
Please follow the instruction for electrical installation of the pyrometer given in
chapter 9. At a normal voltage of 24 V there is no danger for personal health.
Responsibility of user
The device is in technical correct conditions after delivery (please refer to inspection sheet with
signature and stamp), the responsibility for correct handling will be by the user. For eventually pro-
perty damage or personal injury producer liability is impossible. This is only not valid in the case a
verifiable mistake happened by the producer is assessable.
Who can use and maintain the pyrometer?
Using the pyrometer is restricted to qualified personnel which has got instructions before initial
operation and handling. Instructions should be by a supervisor or by staff of Calex.
customer service.
Personal protective equipment
It is not necessary to wear personal protective clothing while working with the device. The
integrated LED pilot light does not cause any danger to health. Eventually occurring hazardous
environments in which the pyrometer is prepared to work may require personal protective clothing.
Safety arrangement
The operation of the pyrometer is only allowed with an extra-low voltage protection of 24V DC.
This voltage does not cause hazards to health and life of the user.
How to prepare your desk before starting the operation
All desks should be according to ergonomic standards and national regulations. For
construction or fixing the pyrometer please refer to chapter 8. Handling the device has to be
according to technical data under 5.2.
Prohibition of changing or rebuilding the device on your own
It is strongly prohibited to do technical changes to the device as long as you do not have
permission by the manufacturer. Contravention to this means the manufacturer will not take over
liability caused through damages. It automatically will cause loss of all guarantee claims against
the manufacturer.
23