Maintenance And Cleaning - Würth master PM 200-E Originalbetriebsanleitung

PM 200 E.book Seite 13 Mittwoch, 29. April 2009 1:32 13
Intended Use
hand-guided angle polisher for commercial use, for
polishing and sanding with sanding discs of metal and
stone, as well as working with wire brushes in
weather-protected environments using the application
tools and accessories recommended by Würth.
This machine is also intended to be powered by a.c.
generators with sufficient power output that correspond
with ISO 8528, design class G2. Compliance with this
Standard in particular is not given when the so-called
distortion factor exceeds 10%. When in doubt, inform
yourself about the generator in use.
For damage caused by usage other then intended, the
user is responsible.
Tool Specifications
Polisher
Article number
Power input
Output
Rated speed
maximum backing pad diameter 250 mm
Thread for clamping flange
Length of mounting thread
Weight according to
EPTA-Procedure 01/2003
Machine Elements
1 Protection guard
2 Spindle lock button
3 On/Off switch
4 Auxiliary handle
5 Polishing wheel
Not all of the accessories illustrated or described are included
as standard delivery.
Operating instructions
Press the locking button only when the motor is stopped.
Selection of accessories
Use only original Würth accessories. The accessories
must be intended for the power tool type.
Use accessories A–G with the safety guard mounted.
A Nettle buffer/Flannel buffer
B Abrasive fleece wheel
C Polishing wheel
D Sanding fleece, polishing rings
E
F
G
Disconnect the mains plug from electric supply.
Blow out the interior of the power tool at regular inter-
vals from outside through the air vents with dry, com-
pressed air.
If the supply cord of this power tool is damaged it must
be replaced by a specially prepared cord available
through the Würth customer service centre.
If required, you can change the following parts your-
self:
Application tools, auxiliary handle, safety guard, work
arbors, flanges.
If the machine should fail despite the care taken in man-
PM 200-E
ufacturing and testing, repair should be carried out by
a Würth Master-Service agent.
0702 453 X
1 200 W For all correspondence and spare parts orders, always
include the article number on the type plate of the
750 W
machine.
-1
900 – 2 500 min
For the current spare parts list of this machine, log into
the Internet under "http://www.wuerth.com/partsman-
M 14
ager" or ask for a copy at your nearest Würth branch
20 mm
office.
2.5 kg
Power tools, accessories and packaging should be
disposed of for recycling in an environmentally
friendly manner.
2002/96/EC for waste electric and electronic equip-
ment and its implementation into national law, power
tools that are no longer usable must be collected sepa-
rately and recycled in an environmentally friendly man-
ner.
Würth will gladly take back your defective Würth
power tool free of charge.
Elastic sanding cylinder, lamella fleece cylinder
Sanding strip roll
Expanding roll for sanding sleeves

Maintenance and Cleaning

Disposal
Only for EU countries
Do not dispose of power tools into house-
hold waste!
According to the European Guide Lines
13