Declaration Of Conformity; Noise/Vibration Information - Würth master PM 200-E Originalbetriebsanleitung

PM 200 E.book Seite 14 Mittwoch, 29. April 2009 1:32 13
Warranty
For this Würth tool, we provide a warranty in accord-
ance with statutory/country-specific regulations from
the date of purchase (proof of purchase by invoice or
delivery note). Damage that has occurred will be cor-
rected by replacement or repair.
Damage caused by normal wear, overloading or
improper handling is excluded from the warranty.
Claims can be recognised only when the tool is pre-
sented undisassembled to a Würth branch office or a
Würth field service employee.

Noise/Vibration Information

Measured values determined
EN 60 745-1.
Typically the A-weighted noise levels of the product are:
Sound pressure level 84 dB(A); sound power level
95 dB(A), peak sound pressure level L
Measuring uncertainty K = 3 dB.
Wear ear protection!
Overall vibrational values (vector sum of three direc-
tions) determined according to EN 60 745.
Mean vibrational value for polishing
overall vibrational value:
h,P
Uncertainty K = 2
1.5 m/s
mean vibrational value for sanding with sanding sheet:
Overall vibrational value
h,DS
Uncertainty K = 1.5 m/s 2
The vibration emission level given in this information
sheet has been measured in accordance with a stand-
ardised test given in EN 60745 and may be used to
compare one tool with another. It may be used for a
preliminary assessment of the vibrational impact.
The declared vibration emission level represents the
main applications of the power tool. However if the
power tool is used for other applications, with different
accessories or poorly maintained, the vibration emis-
sion may differ. This may significantly increase the
vibrational impact over the total working period.
An estimation of the level of exposure to vibration
should also take into account the times when the tool is
switched off or when it is running but not actually doing
the job. This may significantly reduce the exposure level
over the total working period.
Identify additional safety measures to protect the oper-
ator from the effects of vibration such as: Maintain the
power tool and the accessories, keep the hands warm,
organisation of work patterns.
14
We declare under our sole responsibility that this
product is in conformity with the following standards or
standardization documents: EN 60 745-1,
EN 60 745-2-3, EN 55 014-1, EN 55 014-2,
EN 61 000-3-2, EN 61 000-3-3, according to the
provisions of the regulations 98/37/EC (until
28.12.2009), 2006/42/EC (from 29.12.2009),
2004/108/EC.
Adolf Würth GmbH & Co. KG
according to
P. Zürn
= 99 dB(A).
pCpeak
=3.5 m/s 2 .
2
=3.5 m/s .
Subject to change without notice

Declaration of Conformity

09
A. Kräutle