Connecting To The Endoscope; A) Apple Ios - VOLTCRAFT BS-20 Bedienungsanleitung

10. CoNNECTINg To ThE ENdoSCoPE

The connection between your device and the endoscope is established via WiFi. For this, a
WiFi access point is provided on the endoscope. In the delivery condition, it is called "WiFi
endoskop". It is encrypted with WPA2. The associated password is "12345678" (without quota-
tion marks).
Observe the following; When your mobile device is connected to the endoscope, your
normal WiFi network will be temporarily unavailable. This means that you cannot access
the Internet via WiFi during this time.
This of course has no influence on your mobile network (UMTS, LTE).
• Before you can establish the connection, switch on the endoscope (a4) first.
• The green LED at the device lights up for approx. 3 seconds first, then flashes very quickly
for approx. 3 seconds and finally remains lit again for some time.
• Once the starting process is completed and the WiFi access point is running, the LED will
flash green slowly.
• Now you can connect your mobile device to the camera.

a) apple ioS

We describe the configuration based on an iPad with iOS 8.3. However, it is identical
for any other supported Apple device. If you use an older version of iOS there may, of
course, be slight deviations.
• Open the settings on your iPad (gear icon).
• Navigate to the menu item WiFi and tap it.
• After a brief search, the WiFi network "WiFi endoskop" should be displayed.
• Tap it to connect your iPad to the WiFi.
• Enter the password "12345678" (without quotation marks) when prompted.
• Once the connection has been established, the green LED at the endoscope will flash
quickly. Now you can close the settings window and start the app "WiFi endoskop". For this,
tap the corresponding button.
39