Topcom nelson Bedienungsanleitung Seite 21

Nelson
Putting Through Calls R
The flash button R is used to put through a call via the flash system of the
(14)
telephone exchange (PABX). (See operating manual of the telephone exchange.)
Intercom and
(10) (17)
The use of the intercom function between the handset and the baseset is unlimit-
ed and requires no external telephone connection.
From Baseset to Handset
1. To call the handset, press the intercom button
2. The handset starts ringing.
3. Press the intercom button on the handset to answer the call.
(17)
4. The intercom indicator will light for as long as the device is used as an
(9)
intercom, as soon as the intercom call is finished, the intercom indicator
will go out.
From Handset to Baseset
1. To call the baseset, press the intercom button
2. The handset starts ringing.
3. Press the intercom button on the baseset to answer the call.
(10)
4. The intercom indicator will light for as long as the device is used as an inter-
com, as soon as the intercom call is finished, the intercom indicator
go out.
Mute Function
As long as you keep the mute button
your correspondent will not be able to hear you.
36
(14)
on the baseset.
(10)
(9)
on the handset.
(17)
will
(9)
pressed during a conversation,
( 1 8 )
Nelson
MEMORY
Storing a Telephone Number
When the telephone is in the standby mode, 10 telephone numbers can be
stored. Each number can consist of maximum 20 digits.
1. Press the memory button .
(12)
2. The battery indicator blinks.
(8)
3. Press the button (0 - 9) under which you want to store the number.
4. The battery indicator lights continuously.
(8)
5. Dial the number you want to store.
6. Press the memory button to confirm the number.
(12)
7. A confirmation beep will be heard and the battery indicator
In the standby mode, the last number dialled can also be stored under one of the
buttons (0 - 9).
1. Press the memory button .
(12)
2. The battery indicator blinks.
(8)
3. Press the button (0 - 9) under which you want to store the number.
4. The battery indicator lights continuously.
(8)
5. Instead of dialling the telephone number, press the redial button
6. Press the memory button to confirm the number.
(12)
7. A confirmation beep will be heard and the battery indicator
Note:
If for 10 seconds no number is dialled, the memory function will be canceled and
you will have to start again.
Dialling Memory Numbers
1. Press the line button to establish radio contact between handset and
(15)
baseset.
2. First press the memory button
(12)
number you want to reach is stored (0 - 9).
3. The unit will dial the number automatically.
37
goes out.
(8)
.
(16)
goes out.
(8)
and then the button under which the