Küppersbusch IKEF3290-2 Bedienungsanleitung Seite 46

46
Problem
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the Shopping, or
after changing the tempera‐
ture.
Water flows inside the refrig‐
erator.
Water flows on the floor.
Temperature cannot be set.
dEMo appears on the dis‐
play.
Possible cause
The lamp is defective.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor‐
rectly.
The Shopping is switched
on.
This is normal, no error
has occurred.
The water outlet is clog‐
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet is
not connected to the evap‐
orative tray above the
compressor.
The FastFreeze function
or Shopping function is
switched on.
The appliance is in dem‐
onstration mode.
Solution
Contact the nearest Author‐
ised Service Centre.
Refer to "Operation".
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor‐
ing.
Refer to "Closing the door".
Refer to "Shopping function".
The compressor starts after a
period of time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Switch off FastFreeze or
Shopping manually, or wait
until the function resets auto‐
matically to set the tempera‐
ture. Refer to "Fast‐
Freezefunction" or "Shopping
function".
Keep the OK pressed for ap‐
proximately 10 seconds until a
long sound is heard and dis‐
play shuts off for a short time.