Technical Data - Renkforce 1216215 Bedienungsanleitung

• The POWER switch near the power connector is used to switch the loudspeaker on
and off. In the position "O" or "OFF" the power is off; when switched to "I" or "ON"
it is turned on.
• Once you turn on the unit, the display and the status indicator of the battery lights
up.
• While the loudspeaker is switched on, the battery is loaded automatically. You can
recognize this when the green LED "CHARGE", which is located above the word
"POWER" lights up.
• When you put the loudspeaker in operation for the first time, allow the batteries to
fully charge. This takes approx. 12 hours.
The mobile PA system can also be operated while charging.
The status of the charging shows on the 4 LEDs under the word "BATTERY
LEVEL". If only the red LED of the status display illuminates, the battery
should be recharged as soon as possible.
The battery has a low self-discharge, i.e. it discharges slowly even when
the device is not in operation. For this reason, when not in use, you should
charge the battery completely about once a month.
Connection and operation of audio sources
• Before attaching or connecting a device to the loudspeaker you should turn all con-
trols ("MIC VOLUME", "AUX VOLUME", "MASTER VOLUME") all the way back to
the far left, and the volume of the MP3 player should be set to zero with the "VOL"
button.
• With the "MASTER VOLUME" controller, you adjust the entire volume of the loud-
speaker.
With the "MIC VOLUME" controller, you adjust the volume of the input "MIC 1" and
"MIC 2".
With the "AUX VOLUME" controller you adjust the volume of the input "AUX INPUT"
and of a device connected via Bluetooth
With the buttons "VOL+" and "VOL-" you adjust the volume of the MP3 player during
when playing from an SD card and a USB flash drive.
• Before connecting an external device, first turn off the loudspeaker. USB sticks,
memory cards and Bluetooth devices can be connected while the loudspeaker is
®
turned on.
At the "MIC 1" and "MIC 2" entrances you can connect the included microphone in
conjunction to the attached microphone cable. Alternatively, you can also connect
a similar commercially available microphone.
At the "AUX INPUT" entrance you can connect an external device, such as a CD
player.
• After the connection, turn the loudspeaker back on.
• To connect a Bluetooth device to the loudspeaker, press the button for the
®
Bluetooth connection for about 2 to 4 seconds. It is found under the "MASTER
®
VOLUME" controller. If the blue LED next to it starts to flash quickly, let it go again.
Now activate the Bluetooth on your device and pair it with the device "HYBRID
®
DRIVER". If a key is requested, it is "0000".
• If you have a device connected externally or via Bluetooth
control, adjust this one to about 75% of the maximum volume. Make sure that the
signal output is not distorted.
• Start playback on the external device.
• If you prefer to play music from a USB stick or a memory card, connect the stick to
the USB port or insert the memory card into the card slot. The pins on the card must
be facing up.
With the "MODE" button you can switch between the USB port and memory card
slot. If you press the button longer, the MP3 player is switched off or on. Pressing
the "PLAY PAUSE" button starts or pauses playback. With the buttons "NEXT" and
"PREV" you can go forward of backward in a song.
Alternatively, you can use the included remote control. Here you have the option to
choose the track directly by entering the number. You can also use the "EQ" button
to switch through different equalizer settings.
• Start playback of the MP3 player.
• If you started the desired playback, set the "MASTER VOLUME" controller on a me-
dium setting in the first third of the control range.
• Now turn the controller to the desired input slowly to the right. If you use the MP3
player, press the "VOL +" button several times. Even now, you might need to adjust
the setting of the "MASTER VOLUME" controller.
Of course, it is possible to have different playbacks playing in parallel. You
can then adjust the volume with individual controllers together with the
"MASTER VOLUME" controller.
Before you remove a connected cable or turn off an externally connected
device, make sure to turn off the loudspeaker.
.
®
that has its own volume
®
Remote control battery replacement
• If the remote control stops working, the battery must be replaced.
• To do this, pull the battery holder out of the bottom of the remote control. Pay atten-
tion to the illustration on the back of the remote.
• Replace the battery (CR2025). Make sure that the polarity is correct when inserting
the new coin cell. The positive pole must face the back of the remote control.
• Now slide the battery holder into the remote control again until it clicks into place.
Declaration of conformity (DOC)
We, Conrad Electronic SE, Klaus-Conrad-Straße 1, D-92240 Hirschau, hereby declare
that this product conforms to the fundamental requirements and other relevant regula-
tions of the directive 1999/5/EC.
You can find the conformity declaration for this product at www.conrad.com.
Cleaning
Before cleaning the loudspeaker turn it off and disconnect the power cable from the
wall socket!
To clean the outside of the product, a dry, soft and clean cloth is sufficient. Dust can
easily be removed using a clean, long-haired brush and a vacuum cleaner.
Do not use abrasive cleaning agents, cleaning alcohol or other chemical
solutions, since these could damage the housing or even impair operation.
Disposal
a) Product
Electrical and electronic equipment does not belong in the regular house-
hold waste.
Dispose of the waste product in accordance with the applicable legal regu-
lations.
Remove any inserted battery and dispose of it separately from the product.
b) Batteries and rechargeable batteries
As the end user, you are required by law (Battery Regulation) to return used batteries
and rechargeable batteries. Do not dispose of used batteries in the household waste!
Batteries/rechargeable batteries contain harmful materials and are labelled
with the symbol shown to indicate that disposal in the household waste
is forbidden. The symbols of the critical heavy metals are: Cd=cadmium,
Hg=mercury, Pb=lead (marking can be seen on the battery/rechargeable
battery, e.g., underneath the refuse bin symbol shown on the left).
You can return your used batteries/rechargeable batteries free of charge at the official
collection points of your community, in our stores, or at places where batteries or
rechargeable batteries are sold!
You thereby fulfil your statutory obligations and contribute to the protection of the
environment.
Technical data
Operating voltage............................................... 220-240 V/50-60 Hz
Power consumption........................................... max. 30 W
Safety mechanism ............................................. T1 AL/250 V (5 x 20 mm)
Battery life/charging time ................................. max. 12 hours
Output power ...................................................... 15 W (RMS), 1% THD
Frequency range ................................................ 70-20000 Hz
Inputs ................................................................... 2x 6.3 mm Jack Balanced, 1x RCA Stereo
Media supported ................................................ SDHC/MMC Card, Class 4 to 10, USB
Transmission technology wireless/range ...... Bluetooth
Dimensions (W x H x D)..................................... 380 x 440 x 280 mm
Weight .................................................................. 12.6 Kg
Temperatur/humidity during operation ........... -15 °C to +50 °C, 40% to 85% relative
Temperatur/humidity at storage ...................... -20 °C to +60 °C, 40% to 85% relative
Battery for remote control ................................ 1 lithium button cell CR2025, 3 V/DC
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent
the technical status at the time of printing.
© Copyright 2015 by Conrad Electronic SE.
sticks, max. 64 GB
3.0 + EDR, max. 20 m
®
humidity
humidity