Setting Alarm Times (Alarms 1 And 2) - Silvercrest KH 2281 Bedienungsanleitung

Programming the kitchen timer
You can save kitchen timer periods.
1. TIMER/ALARM MODE
Press the button
TUNING UP/DOWN
2.
Using the button
in the desired time.
STORE
3.
Press the button
blinks.
4. 1/3 PRESET, 2/4 PRESET
Press the button
required save position. There are four save
locations at your disposal. In the display the
number of the selected save location appears.
STORE
5.
Press the button
period is now saved.
If a button is not pressed within ten seconds, the
kitchen radio switches back to time display.
6.
To recall the saved kitchen timer settings, press
TIMER/ALARM MODE
the button
of the corresponding memory save location (
PRESET, 2/4 PRESET
o
7. TIMER/ALARM MODE
Press the button
more to start the kitchen timer. A clock symbol
running in an anti-clockwise direction appears
on the display.
8.
To switch the kitchen timer off, hold the button
TIMER/ALARM MODE
t

Setting alarm times (Alarms 1 and 2)

You can programme two alarm times into your
kitchen radio.
Alarm function Symbol in the display
Acoustic signal
Radio
Switched off no symbol
ALARM 1/VOL+
1.
Press the button
VOL-
i
). The last set alarm time for A1 resp. A2
and, possibly, the symbol for the type of alarm
(see table above) are shown on the display.
t
.
g
programme
f
. In the display "T"
o
for the
f
once again. The time
t
and the button
).
t
once
pressed down.
ALARM 2/
y (or
2.
Press the button
desired alarm time.
3.
Press the button
VOL-
i ) repeatedly until the desired alarm type
(see table above) is shown in the display.
4.
Press the button
on which you require the alarm function:
You can select between workdays (Mo, Tu,
We, Th, Fr), weekends (Su, Sa), whole weeks
(Su, Mo, Tu, We, Th, Fr, Sa) or the present
weekday. The selected setting is shown on the
display.
5.
Press the button
desired alarm days are programmed in. Keep
the button
day appears on the display.
1/3
6.
Press the button
weekday.
To return to the selection of workdays, weekends or
whole weeks, once again hold the button
briefly pressed down.
7.
Press the button
programming and to return to time display.
When the alarm signal sounds...
• and the alarm function "Radio" has been selected,
the radio plays for one hour at a pre-defined
alarm volume. This volume level cannot be
changed. To finish it, press the button
1/VOL+
y
or
• and the alarm function "Signaltones" has been
selected, the signal tone sounds for 10 minutes.
To finish it, press the button
ALARM 2/VOL-
- 7 -
TUNING UP/DOWN
g
ALARM 1/VOL+
y
(or
A.O.T.
d
to set the weekdays
A.O.T.
d
repeatedly until the
A.O.T.
d
pressed down until a single
A.O.T.
d
to set the required
MODE SET/BASS
j
to save the
ALARM 2/VOL-
i
.
ALARM 1/VOL+
i
.
to set the
ALARM 2/
A.O.T.
d
ALARM
y
or