Reading Led Indicators; Installing The Battery; Charging The Battery - AIPTEK pocketcinema t10 Handbuch

Reading LED indicators

The Power LED is lighting green when projector is turned on.
The Battery LED is flashing orange when battery life level is low.
The Battery LED is lighting orange when projector is being charged.

Installing the battery

1. Slide the battery cover open.
2. Place the included Li-Ion battery
into the compartment. Note that the
metallic contacts must be aligned with
the contacts in the compartment.
3. After the battery is properly installed,
replace the battery cover.

Charging the battery

Please charge the battery at least 3 hours prior to its first use.
1. Connect the cable.
Connect one end of the supplied AC adapter to the DC IN jack
(mini USB type) of the projector and the other end to a wall
outlet.
2. The Battery LED turns orange and the charge starts.
3. When the charging is interrupted or the battery pack is fully
charged, the Battery LED will turn off.
Turning on/off your projector
Press and hold down the Power button for 2 seconds to turn on the projector.
To turn off the projector, press and hold down the Power button for 2 seconds.
Without inputting any video signals into this projector, there is a blue projection
screen with battery status icon if powered by battery.
If there is no signals found for 2 minutes, the projector will automatically turn off for
saving power.