Using The Subwoofer; Pre-Adjusting The Subwoofer Volume - Yamaha YST-SW012 Bedienungsanleitung

Using the subwoofer

Subwoofer rear panel
1
1
Power indicator
Lights up in GREEN when the POWER switch
(2) is turned ON; turns off when the POWER
switch is turned OFF.
2
POWER switch
Press this switch to the ON position to turn on
the power to the subwoofer. When the power of
the subwoofer is on, the power indicator (1) on
the rear panel lights up in green. Press this
switch again to set it to the OFF position to turn
off the power of the subwoofer.
3
VOLUME control
Adjusts the volume level. Turn the control
clockwise to increase the volume, and counter-
clockwise to decrease the volume.
4
INPUT terminal
Input terminal for line level signals from the
amplifier.
4
4
INPUT
3
VOLUME
INPUT
VOLUME
2
POWER
ON
OFF
POWER
Pre-adjusting the subwoofer
volume
Before you use the subwoofer, first adjust the vol-
ume balance between the subwoofer and the front
speakers by following the procedure below.
1.
Set the VOLUME control to minimum (0).
2.
Turn on the power to all other components.
3.
Press the POWER switch to the ON position.
The power indicator on the rear panel lights up
in green.
4.
Play a source that contains bass signal. Adjust
the amplifier's volume control to the desired lis-
tening level.
5.
ON
Rotate the VOLUME control gradually to
adjust the volume balance between the sub-
OFF
woofer and the other speakers. To enjoy natural
bass sound, keep the subwoofer volume at a
level where it is barely distinguishable from
other speakers.
6.
Adjust the volume of the entire sound system
using the amplifier's volume control.
Note:
It is recommended to set the
VOLUME control about in the middle
position when using in a multi channel
home theater system.
VOLUME