Yamaha KX-W321 Bedienungsanleitung Seite 10

DOLBY NR selector setting (in step 2)
Set the DOLBY NR selector according to your purpose.
OFF: No noise reduction.
B: For recording the sources with Dolby B NR.
C: For recording the sources with Dolby C NR.
÷ Dolby noise reduction is an extremely effective method of
reducing undesirable background hiss on tapes. This unit
incorporates both Dolby B NR and the newer Dolby C NR
system. Dolby C NR is approximately twice as effective
as the earlier Dolby B NR.
REVERSE MODE selector setting (in step 3)
The auto reverse function allows the tape running direction
to be reversed automatically. Select the auto reverse mode
(
) or manual reverse mode (
: When recording on one side of a tape is finished, the
deck stops at the end of the tape.
:Both sides of a tape are recorded. After recording,
the deck stops at the end of the tape.
÷ When the tape running direction is set to ™, only
the reverse side is recorded.
÷ If you select
or
automatically switches to
Display during recording
The A or B indicator shown in
the display represents the
last deck operated.
KX-W421/
KX-W321
Peak level meters
Indicate the peaks of the signal levels during recording and playback over a –30 dB to +6 dB range. There are separate meters
for each left and right channel. These level meters have a peak hold function which holds the peak level for about 1.5 seconds.
To stop recording:
Press the & button.
10
).
, the reverse mode
RELAY
in step 5.
Tape counter
Use the tape counter to aid in locating a point on a tape (0000 to 9999).
To set the counter reading to "0000", press the RESET button.
Tape running direction indicator
¤
L
—
30 dB 20 15
R
Setting the recording level (in step 6)
Play the loudest passage of the source to be recorded and
watch the meter readings.
Adjust the REC LEVEL control so that the highest peak
reaches +4 of the optimum recording level. Normally, it is
best to adjust the REC BALANCE control (KX-W421 only)
such that the left and right meter readings are even.
MODE indicator
‹ ¤
RELAY
A
B C
10 8 6 4 2
To stop recording temporarily:
Press the REC/PAUSE button. To resume recording, press
the PLAY button.
DOLBY B/ C indicator
REC indicator
‹
B
REC
6 +
0 2 4