Mono Operation; Stereo Operation - Monacor MMX-8 Bedienungsanleitung

5 Mono Operation

In mono operation up to 8 mono signal
sources may be connected to the inputs
(10).
1) The upper jack OUTPUT A (9) serves
as an output. An amplifier or a
recorder is connected to this jack. If
microphones are connected to the
mixer, the mixer has to be connected
to the microphone input of the ampli-
fier or recorder. The lower jack OUT-
PUT B is out of operation.
2) Set the selector switch MONO /
STEREO (6) to MONO.
3) Select the type of signal source with
the selector switches MIC / LINE (2):
MIC = microphone
LINE = line input (tuner, CD,
cassette)
4) To prevent switching noise, set both
controls MASTER A (5) and MAS-
TER B (4) to "0". Switch on the unit
with the switch ON / OFF (7) on the
rear side. First the LEDs PEAK (3)
shortly light up at maximum bright-
ness and then continue to light at
lower brightness.
5) Set the controls VOLUME (1) of the
channels to which no unit has been
connected to "0". Set the other con-
trols to mid-position first.
6) Turn up the control MASTER A (5) so
that the upper level indication PEAK
(3) shortly lights up with music peaks
at maximum brightness.
7) Adjust the mixing ratio of the inputs
with the controls VOLUME (1) ac-
cordingly. Correct the output level with
the control MASTER A (5), if required.
8) Individual channels are faded in and
out with the corresponding controls
VOLUME (1), if required. The output
signal is faded in and out with the
control MASTER A (5).

6 Stereo Operation

In stereo operation up to 4 stereo signal
sources may be connected to the inputs
(10). The left channels are always con-
nected to the jack A and the right chan-
nels to the jack B.
1) Connect an amplifier or a recorder to
the jacks (9) OUTPUT A (left channel)
and OUTPUT B (right channel). If mi-
crophones are connected to the
mixer, the mixer must be connected
to the microphone input of the ampli-
fier or recorder.
2) Set the selector switch MONO /
STEREO (6) to STEREO.
3) Select the type of signal source with
the selector switches MIC / LINE (2):
MIC = microphone
LINE = line input (tuner, CD,
cassette)
Both selector switches MIC / LINE
must be set to the same position.
4) To prevent switching noise, set both
controls MASTER A (5) and MAS-
TER B (4) to "0". Switch on the unit
with the switch ON / OFF (7) on the
rear side. First the LEDs PEAK (3)
shortly light up at maximum bright-
ness and then continue to light at
lower brightness.
5) Set the controls VOLUME (1) of the
channels to which no unit has been
connected to "0". Set the other con-
trols to mid-position first.
6) Turn up the controls MASTER A (5)
and MASTER B (4) so that the level
indications PEAK (3) shortly light up
with music peaks at maximum bright-
ness.
7) Adjust the mixing ratio of the inputs
with the controls VOLUME (1) ac-
cordingly. Correct the output level
GB
9