Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.3 Remote control
To insert the batteries (2 × 1 .5 V, size AAA),
remove the battery compartment cover on
the rear side of the remote control . Insert the
batteries as indicated in the compartment . Close
the cover . If the remote control is not used for
a longer time, remove the batteries as a pre-
caution so that the remote control will not be
damaged in case the batteries should leak .
When the operating range of the remote
control decreases, the batteries are discharged
and must be replaced .
Discharged batteries must not be
placed in the household waste; always
take them to a special waste disposal,
e . g . collection container at your retailer .
5 Operation
1) Prior to initial switch-on, set all volume con-
trols (5, 7, 9) to "0" to avoid an unexpectedly
high volume when the unit is switched on .
2) Switch on the audio sources connected .
3) Use the POWER switch (16) to switch on the
MXT-52MP3 . The power indicator ON (15)
will light up .
4) Switch on the amplifier connected .
5) Replay music, for example, from an audio
source or speak into a microphone (operation
of the audio player
6) To adjust the volume of the audio sources,
use the control (5) of the corresponding con-
nection .
To adjust the volume of the audio player, use
the volume control MP3 (7) or the remote
☞
control (
Adjust the total volume with the control VOL-
UME (9) . When the output is overloaded,
the signal will be distorted and the LED indi-
cator CLIP (6) will light up . In this case, turn
back the control of the corresponding audio
source or the control VOLUME accordingly .
7) Use the controls (8) BASS and TREBLE to
adjust the tone as desired .
8) After operation, first switch off the amplifi-
er and then use the POWER switch (16) to
switch off the mixer .
10
☞
chapters 5 .1 and 5 .2)
chapter 5 .2) .
5.1 Audio player
The integrated audio player is able to replay
audio files in the formats MP3 and WMA . As
storage media, USB flash drives or SD[HC] mem-
ory cards (also MMC cards) can be used .
Note: Due to the large number of storage device manu-
facturers and device drivers, it cannot be guaranteed that
all storage media are compatible with the audio player .
Connect a USB flash drive to the USB port (2)
or / and insert a memory card (contacts facing
upwards) into the slot (3) until it engages . To
remove the card, slightly push the card into the
slot until it disengages .
When the unit is switched on, the replay of
the audio file most recently replayed will start .
When a storage medium is connected during
operation, the replay will start from this medi-
um . The LED indicator at the connection of the
storage medium currently used will light up .
The audio player can be operated via the but-
tons (4) or the remote control supplied (fig . 4)
☞
(
chapter 5 .2) . When pressing a button,
always point the remote control to the audio
player . Make sure that there are no obstacles
between the remote control and the audio
player .
The display (1) will indicate the storage
medium selected (
USB
current title and the file type (
the replay is started or when a title in a different
folder is selected, the number of the folder will
be briefly indicated ( xx) .
The volume of the replay depends both on
on the remote control and on the volume
VOL− /+
control MP3 (7) .
/
), the number of the
CARD
/
) . When
MP3
WMA
Werbung
Inhaltsverzeichnis
