Mono Operation; Stereo Operation - Monacor MMX-8 Bedienungsanleitung

Do not put exhausted batteries
into the household rubbish but
take them to a special waste
disposal (e. g. collective con-
tainer at your retailer).

5 Mono Operation

In mono operation up to 8 mono signal
sources may be connected to the in-
puts (8).
1) The upper jack OUTPUT L (7) serves
as an output. An amplifier or a
recorder is connected to this jack. If
microphones are connected to the
mixer, the mixer has to be connected
to the microphone input of the ampli-
fier or recorder. The lower jack OUT-
PUT R is out of operation.
2) Set the selector switch MONO /
STEREO (4) to MONO.
3) Select the type of signal source with
the selector switches SOURCE (2):
MIC = microphone
LINE = line input (tuner, CD,
cassette)
4) To prevent switching noise, set both
controls MASTER LEFT and MAS-
TER RIGHT (3) to "0". Switch on the
unit with the switch ON / OFF (5) on
the rear side. First the LEDs ON PK
above the controls shortly light up at
maximum brightness and then con-
tinue to light at lower brightness.
5) Set the input controls (1) of the chan-
nels to which no unit has been con-
nected to "0". Set the other controls
to mid-position first.
6) Adjust the output level with the con-
trol MASTER LEFT (MONO) so that
the following unit is adjusted to an
optimum level.
7) Adjust the mixing ratio of the inputs
with the input controls (1) accord-
ingly. The LED ON PK above the
control MASTER LEFT (MONO)
serves as a level indicator. Correct
the output level with the control MAS-
TER LEFT (MONO), if required.
8) Individual channels are faded in and
out with the corresponding input con-
trols (1), if required. The output signal
is faded in and out with the control
MASTER LEFT (MONO).

6 Stereo Operation

In stereo operation up to 4 stereo signal
sources may be connected to the inputs
(8). The left channels are always con-
nected to the upper jack and the right
channels to the lower jack.
1) Connect an amplifier or a recorder to
the jacks (7) OUTPUT L (left chan-
nel) and OUTPUT R (right channel).
If microphones are connected to the
mixer, the mixer must be connected
to the microphone input of the ampli-
fier or recorder.
2) Set the selector switch MONO /
STEREO (4) to STEREO.
3) Select the type of signal source with
the selector switches SOURCE (2):
MIC = microphone
LINE = line input (tuner, CD,
cassette)
Both selector switches SOURCE
must be set to the same position.
4) To prevent switching noise, set both
controls MASTER LEFT and MAS-
TER RIGHT (3) to "0". Switch on the
unit with the switch ON / OFF (5) on
the rear side. First the LEDs ON PK
above the controls shortly light up at
maximum brightness and then con-
tinue to light at lower brightness.
GB
9