Yamaha Soavo-900C Bedienungsanleitung Seite 3

Before making connection, make sure that the amplifier is switched off.
• Connect the screw-type terminals at the rear of the
speaker to the speaker terminals of the amplifier with the
speaker cable (sold separately).
• Connect the (+) terminals on the amplifier and the
speaker using one side of the cable. Connect the
(–) terminals on both components using the other side of
the cable.
• Connect the speaker to the center terminals of your
amplifier, making sure not to reverse the polarity (+, –). If
the speaker is connected with reversed polarity, the
sound will be unnatural and lack bass.
How to connect:
1
Loosen the knob.
2
Remove the insulation coating at the extremity of each
speaker cable by twisting the coating off.
Good No Good
10 mm
(3/8")
3
Insert the bare wire in to the hole.
4
Tighten the knob and secure the cable.
Test the firmness of the connection by pulling lightly on
the cable at the terminal.
Notes
• Do not let the bare speaker wires touch each other
as this could damage the speaker or the amplifier, or
both of them.
• Do not insert the insulation coating into the hole.
The sound may not be produced.
When using a banana plug
1
Unscrew the terminal knob.
2
Remove the cover by pulling it toward you.
2
1
CONNECTION TO YOUR AMPLIFIER
Loosen
Black (–)
Bare wire
Amplifier
3
Tighten the terminal knob.
4
Simply insert the banana plug into the terminal.
4
Banana plug
Tighten
Red (+)
Insulation coating
Soavo-900C
CENTER
+
–
3
3
En