Controls And Connections - Grundig APOLLO 2000 Handbuch

10
OVERVIEW

Controls and connections

POWER
LINE IN
RESET
________________________________________________________________________
POWER Switches the loudspeaker on and off again.
The loudspeaker is completely disconnected from the
mains.
Indicators In the mains button:
Red: the loudspeaker is in Stand-by mode;
Green: the loudspeaker is in operation;
Orange: the loudspeaker is in Installation mode;
Flashing green and orange: Reset mode;
Flashing red: the protective circuit has been
actuated.
Reset Button located on the bottom of the casing to reset
the loudspeaker to its original state.
Ü Ü Mains cable.
LINE IN Audio signal input on the bottom of the casing.
For special applications or if you want to connect
your RCD 2000 HiFi system to the loudspeakers
using a cable (Room 1 only).
Note:
If the protection circuit is actuated, switch off the
loudspeaker using the »POWER« button and let it
cool down for at least 15 minutes.