Placing The Speakers - Yamaha NS-B901 Bedienungsanleitung

The grille is detached from the speaker and packed sepa-
rately. Be careful not to lose it.
Place the speakers on a sturdy, vibration-free surface, on a
well-built stand.
■ Using as 2ch stereo speakers
Better stereo images will be obtained when the speakers
are slightly angled in towards the listeners.
■ Using as front speakers in a multi channel
system
Position the speakers on both sides of the TV. The position-
ing of speakers is important, because it controls the whole
sound quality of a multi channel system. Set up the speak-
ers on the basis of your listening position by following the
owner's manual supplied with your amplifier.
■ Using as presence or surround speakers
Place the speakers on a shelf etc. Determine the best
position by following the owner's manual supplied with your
amplifier.
NS-B901
Presence
NS-B901
Front
Note
Placing the speakers too close to a CRT-type TV
may impair the picture color or cause a buzzing
noise. In this case, move the speakers at least 20 cm
(8") away from the TV. This is not an issue with LCD
and plasma TVs.
1
En
PLACING THE SPEAKERS
Subwoofer
Center
NS-B901
Surround
When hanging on a wall
You can hang the speaker on a wall using a commer-
cially available bracket and screws.
Please refer to the owner's manual that came with your
speaker bracket.
Safety wire bracket
Use to attach a safety wire
after mounting the speaker
bracket.
WARNING
• This speaker weighs 5.9 kg (13 lbs.). Do not mount
it on thin plywood or a wall with soft surface
material. If mounted, the screws may come out of
the flimsy surface and the speaker may fall. This
damages the speaker or causes personal injury.
• Do not install the speaker to a wall with nails,
adhesives, or any other unstable hardware. Long-
term use and vibrations may cause it to fall.
• Be careful not to pinch the speaker cables between
the speaker and the speaker bracket or speaker
stand.
• To avoid accidents resulting from tripping over
loose speaker cable, fix it to the wall.
Screw holes
Diameter: 6 mm (1/4")
Hole depth: 15 mm (5/8")
60 mm
(2-3/8")