Silvercrest SBH 3.0 C1 Bedienungsanleitung Seite 51

 The LED (2) now flashes blue and orange alternately.
The headset will now remain in search mode for
approx. two minutes. During this time you can use the
Bluetooth® function to connect a compatible mobile
phone to the headset.
 Now connect your mobile phone to the headset via
®
Bluetooth
manual. From the list of devices detected, select device
'SBH 3.0 C1' and establish the connection. Enter
'0000' if you are asked for a PIN.
Once a connection is established, the LED (2) briefly
flashes blue once approx. every three seconds. As soon
as the mobile phone is switched off or is out of range, a
search is performed (the LED (2) rapidly flashes blue
several times) or the headset goes into standby mode (not
connected) and the LED (2) briefly flashes blue once
every ten seconds (depends on the phone model).
Bring the mobile phone back into range of the headset or
switch it on to re-establish the connection to the headset
. To do so, refer to your mobile phone
SilverCrest SBH 3.0 C1
English - 49