Alde Compact 3010 Betriebsanleitung Seite 6

4. Adjust the desired room temperature up or down
The vehicle's temperature can be set from +5°C to
+ 30°C in intervals of 0,5°C.
1 Press the button with the arrow
until the symbol for selecting
temperature flashes. The
temperature shown is the
temperature which is installed at
present (in this case, 22.0°C).
blinkar
flashes
5. Increase the quantity of hot water
If you need additional hot water, you can increase the
quantity temporarily for 30 minutes. The hot water
temperature will increase from 50°C to 65°C until the
1 Press the button with the arrow
until the symbol for selecting
warm water flashes. The text
"OFF" is displayed next to the
temperature on the display.
blinkar
flashes
If you wish, you can switch off the extra warm water until
30 minutes have elapsed.
1 Press the button with the
arrow until the symbol for extra
warm water flashes. The "ON"
text is displayed next to the
temperature on the display.
blinkar
flashes
6. Heating with gas
Do as follows to activate heating with gas.
1 Press the button with the arrow
until the symbol for gas heating
flashes. The text "OFF" is shown
next to the temperature on the
display.
blinkar
flashes
6
GB
2 Increase the temperature by
pressing the +/On button.
Reduce the temperature by
pressing the -/Off button. The
diagram shows that we have set
the temperature at 25.0°C.
blinkar
flashes
2 Switch on extra warm water by
pressing the +/On button. The
text "ON" is shown next to the
temperature on the display.
blinkar
flashes
2 Switch off the extra warm water
by pressing the -/Off button. The
text "OFF" is shown next to the
temperature on the display.
blinkar
flashes
2 Activate gas heating through
pressing the +/On button. The
text "ON" is shown next to the
temperature on the display.
blinkar
flashes
3 Press the left-hand button twice
– the control panel goes back to
standby.
öka
increase
temp
temp
30 minutes has elapsed. When additional hot water is
selected the circulation pump will stop.
3 Press the left-hand arrow
until the control panel reverts
to standby. The symbol for
extra warm water is constantly
displayed.
3 Press the arrow to the left until
the control panel reverts to
standby. The symbol for extra
warm water has now gone out.
3 Press the arrow to the left until
the control panel reverts to
standby. The symbol for gas
heating is displayed constantly.