Resetting The System - Alde Compact 3010 Betriebsanleitung

CONTROl PANEl – FUNCTIONS AND SyMBOlS
0. Standby mode in the control panel
The control panel goes to standby automatically after
two minutes if no buttons are pressed.
1 The control panel is in standby
and the heater is off.

1. Resetting the system

1 Press the "Store/Reset" button
for 10 seconds. The control panel
will only reset in standby mode.
2. Start the heater
Start the heater with the last stored settings.
1 Press the button with the arrow,
"OFF" flashes in the display.
blinkar
flashes
3. Switch off the heater
1 Press the button with the arrow.
"On" flashes in the display.
blinkar
flashes
In standby, anything activated in the boiler is displayed.
2 The control panel is in standby
and the heater is on.
2 The control panel display shows
that the boiler is "off". LPG gas is
"on". 230 V Electric is "on" 1kW.
The currant room temperature is
also displayed.
If the 12 V supply is disconnected the settings used at
that time will be stored.
2 Press the +/On button. "On"
flashes in the display.
blinkar
flashes
2 Press the -/Off button. "Off"
flashes in the display.
blinkar
flashes
GB
Pump is in automatic mode. The
bottom menu row is not lit up.
3 Press the arrow on the left-hand
side and the settings are ready.
"ON" shows constantly in the
display.
3 Press the arrow to the left and
the settings are ready. "Off"
shows constantly in the display.
5