Key Sound - Alde Compact 3010 Betriebsanleitung

16. Automatic start of heater
With this function you can set the heater to switch on
for 24 hours at the same time every week.
1 Press the button with the arrow
until the "AutoOn" symbol
flashes. "OFF" is displayed.
blinkar
flashes
17. Menu Menu
In the "Menu" mode, one can activate a number of functions. To activate the
function, you first have to make the bottom row of functions light up.
To step through the different functions, use the arrow keys.
OFFSET
(temperature adjustment).
Using this function you can
calibrate the temperature on
the panel if you note that the
temperature (the stabilising room
temperature) is not the same as
the temperature that the panel
indicates
1 Press the button with the arrow
until the Menu symbol flashes.
Press +/On.
PUMP 12V/PUMP AU.
In the PUMP 12 mode, the 12V
pump is used, including when
230V is connected. In the PU AU
mode, 230V works the pump, and
when 230V is disconnected, the
12V pump starts. When the heater
is reset, PU AU is activated.
1 Press the button with the arrow
until the Menu symbol flashes.
Press +/On.

Key sound

With this function, you can
connect or disconnect the key
sound to the keys. The key sound
is disconnected in the factory
settings.
1 Press the button with the arrow
until the Menu symbol flashes.
Press +/On.
10
GB
AutoOn
2 Press the +/On button. The start
time will be shown. Set according
to item 12 and press "Store". OFF
is displayed.
blinkar
flashes
2 When OF is displayed, press
+/On and adjust the change in
temperature with +/On or -/Off
(+/- 5 ºC in intervals of 0.5 ºC).
2 When OF is displayed, step with
the arrow key until PU AU is
displayed. Press +/On and PU 12
will be displayed.
2 When OF is displayed, step
with the arrow key until Sn is
displayed. Press +/On and the
button sound will be connected
up.
For instance you can set the heater to start on Fridays
so that the vehicle is warm for weekends.
3 Press the +/On button to activate
the function. Switch the boiler
off, AutoOn is displayed in
the symbol field. The settings
are saved if the voltage to the
heater is broken when AutoOn is
activated.
3 Press Store to leave the
OFFSET function.
blinkar
flashes
3 Press -/Off and PU AU will be
displayed. Press Store to leave
the pump function.
blinkar
flashes
3 Press -/Off to disconnect the
button sound. Then press
Store to leave the button sound
function.
blinkar
flashes
blinkar
flashes
blinkar
flashes
blinkar
flashes
blinkar
flashes