Fault Messages - Miele Professional WS 5240 Container Gebrauchsanweisung

Problem solving guide
First position the screwdriver in the opening,
push in and hold firm.
Press against the door handle with your right
hand, and then pull on the door handle to
open the door.
- Never use force to open the door. -
Take out the laundry.

Fault messages

Repairs to machines should only be under-
taken by a suitably qualified service engineer
to ensure safety. Unauthorised repairs could
be dangerous.
Faults that occur before or after the start of a
programme are displayed in a flashing display.
PROGRAMME
PROGRAMME STOP
THROUGH POWER CUT
Please press the Start button.
When power is restored press the Start
button X.
This fault message can also indicate that the
winding protection of the drive motor has over-
heated. Allow the motor to cool down.
«M.-Nr. 06 411 840 - GB - »
1 Universal 50°C
Should the water inlet become blocked,
"Water inlet fault" will be displayed and the
programme terminated.
PROGRAMME
PROGRAMME STOP
WATER INLET FAULT
Open water stopcock and press Start button.
Open water stopcock and press the Start
button X.
PROGRAMME
PROGRAMME STOP
DRAIN FAULT
Clean drain system and press Start button.
Check the drainage system on site and press
the Start button X. A defective drain valve
should only be repaired by an authorised
service engineer.
PROGRAMME
PROGRAMME STOP
HEATING SYSTEM FAULT
Short circuit on heater sensor 1
Call the Service department.
PROGRAMME
PROGRAMME STOP
HEATING SYSTEM FAULT
Cut-out of heating sensor 1.
Call the Service department.
PROGRAMME
PROGRAMME STOP
HEATING SYSTEM FAULT
Call the Service department.
PROGRAMME
PROGRAMME STOP
DRIVE SYSTEM FAULT
Multiplug drive variants lacking.
Call the Service department.
20
1 Universal 50°C
1 Universal 50°C
1 Universal 50°C
1 Universal 50°C
1 Universal 50°C
1 Universal 50°C