Miele Professional WS 5240 Container Gebrauchsanweisung Seite 21

Problem solving guide
PROGRAMME
50 °C Main wash
Rinses
DRIVE SYSTEM FAULT
Clean the ventilation slot for the cooling fan,
(see page 22).
Call the Service department, if there is still no
drum movement 30 minutes after this mess-
age appeared.
PROGRAMME
PROGRAMME STOP
IMBALANCE SWITCH
Press the On-Off switch.
Press the Off button Z and the On button Y.
PROGRAMME
PROGRAMME STOP
HEATER SYSTEM FAULT
Dry step switch has cut out.
Call the Service department.
Possible reasons for increased levels of
foaming:
– detergent type
Only use detergent formulated for use in
commercial washer extractors. Domestic
laundry detergent is not suitable.
– overdosing of detergent
Dispense detergent following the detergent
manufacturer's instructions on the packaging
and in accordance with local water hardness
levels*.
– detergent creates too much foam
Use a lower foaming detergent or contact
your detergent application specialist.
1 Universal 50°C
20 °C
1
1 Universal 50°C
1 Universal 50°C
– very soft water
In areas with hardness level 1 dispense
less detergent in accordance with the
detergent manufacturer's instructions.
– soiling level of the laundry
For lightly soiled laundry dispense less
detergent in accordance with the deter-
gent manufacturer's instructions.
– small loads
Reduce the amount of detergent dis-
pensed according to the size of the load.
In "Position B" it is possible to reduce the
drum speed and the wash rhythm during
the heating-up phase in Programme 14.
Water hardness levels
Hardness Water
range quality
I soft
II medium
III hard
IV very hard
*) If you do not know the hardness level of the
water in your area you should contact your
local water authority for information.
Large articles of laundry stretching during
the spin cycle.
Large articles of laundry might stretch during
the spin cycle.
21
Hardness German
level in hardness
mmol/l level °d
0 – 1.3 0 - 7
1.3 – 2.5 7 - 14
2.5 – 3.8 14 - 21
over 3.8 over 21
«M.-Nr. 06 411 840 - GB - »