Beko WMB 51220 Handbuch Seite 37

by pulling out the plug at the end of the
hose. If the amount of water to be drained
off is greater than the volume of the
container, replace the plug, pour the water
out, then resume the draining process.
• After draining process is completed, replace
the plug into the end of the hose and fit the
hose back into its place.
If your product is not supplied with an emergency
drain hose, do the following as shown in the
figure below:
• Place a large container in front of the filter to
receive water flowing from the filter.
• Loosen pump filter (anticlockwise) until water
starts to flow out of it. Direct the flowing
water into the container you have placed
in front of the filter. You can use a piece of
cloth to absorb any spilled water.
• When there is no water left, turn the pump
filter until it is completely loose and remove
it.
• Clean any residues inside the filter as well as
fibers, if any, around the propeller region.
• If your product has a water jet feature, be
sure to fit the filter into its housing in the
pump. Never force the filter while replacing
it into its housing. Fit the filter fully into its
housing; otherwise, water may leak from the
filter cap.
4- Close the filter cap.
Close the two-piece filter cap of your product by
pushing the tab on it.
Close the one-piece filter cap of your product by
fitting the tabs on the bottom into their positions
and pushing the upper part of it.
50 - EN