Device Elements; Emptying The Dirt Container - Kärcher NT 27/1 Me Originalbetriebsanleitung

Device elements

1 Nameplate
2 Power cord
3 Holder for suction pipes
4 Holder for crevice nozzle
5 Suction hose
6 Suction head lock
7 Steering roller
8 Dirt receptacle
9 Suction support
10 Floor nozzle
11 Suction pipe
12 Main switch
13 Suction head
14 Carrying handle
15 Cable hook
16 Bender
17 Cartridge filter
18 Fastening nut
19 Float
Dry vacuum cleaning
Caution
For dry vacuuming, the cartridge filter must
always be installed.
To vacuum fine dust, you can also use
–
an additional paper filter bag.
Inserting the paper filter bag
Illustration
Illustration
Release and remove the suction head.
Insert the paper filter bag.
Insert and lock the suction head.
Wet vacuum cleaning
Inserting the rubber lips
Illustration
Remove the brush strips.
Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
12
Start up
Remove the paper filter bag
To suck wet dirt, first remove the paper
–
filter bag.
Installing an additional filter
Release and remove the suction head.
Turn the suction basket by 180° and
keep it aside.
Loosen the mounting nuts
Remove the cartridge filter.
Illustration
Insert the fastening nut and tighten it.
Install the additional filter.
Insert and lock the suction head.
Clip connection
Illustration
The suction hose is equipped with a clip
system. All C-35/C-DN-35 accessories can
be connected.
Turning on the Appliance
Plug in the main plug.
Switch on the appliance at the main
switch.

Emptying the dirt container

The vacuum channel is equipped with a
–
float.
When the dirt water reaches the highest
–
permissible level in the container, the
suction power is interrupted.
Switch off the appliance at the main
switch.
Empty the dirt container.
Turn off the appliance.
Switch off the appliance at the main
switch.
Pull out the mains plug.
After each operation
Empty the dirt container.
Vacuum and wipe the appliance inside
and outside with a damp cloth.
2
-
EN
Operation