Controls And Components; Technical Data; Features Of The Product - Grundig VCW 7230 Bedienungsanleitung

2 Overview

2.1 Controls and components

1. Mode button for adjustion water amount
2. On-Off Button
3. Self Cleaning Activation Button
4. Handle
5. LED Screen + Self-cleaning touch
6. Dirty Tank Strainer
7. Dirty Tank
8. Brush Roller Cover
9. Brush Roller
10. Floor Brush Component
11. Fresh Water Tank

2.2 Technical data

Nominal input power: 250 W
Input: 100-240V~ 50/60 Hz 0.8A
Waterproof: IPX 4
Output:22.0V 1.0 A
Charging period: 4-5 hours
Operation period under
maximum power: 16 mins
Operation period under
minimum power: 25 mins

2.3 Features of the Product

This appliance contains three functions: Vacuuming;
Mopping and Self-cleaning.
Fresh Water Tank Capacity:740 ml
Dirty Water Tank Capacity: 500 ml
Parameter of External Power Supply
Manufacturer: E-TEK Electronics
Manufactory Co., LTD
Model Identifier: ZD024M220100EU
Input Voltage: 100-240Vac
The values provided with the appliance or its accompanying documents are laboratory readings in
accordance with the respective standards. These values may differ depending on the use and ambient
conditions.
Wet&Dry Upright Vacuum Cleaner / User Manual
Input Frequency: 50/60Hz
Input Current: 0.8A
Output Voltage: 22.0Vdc
Output Current: 1.0 A
Output Power: 22.0W
Average active efficiency: 88.25%
Efficiency at low load(10%): 84.57%
No-load power consumption: 0.08W
2.3.1Floor Surface Cleaning
The product is equipped with fresh water tank, dirty
tank, brush roll, motors, and other functional modules.
The water pumps to the brush roll, and the motor
drives it to rotate at high speed to clean up surfaces.
After cleaning, the dirty are recycled to the dirty tank
by the suction motor. During the cleaning process, the
water spraying function can be turned off according
to the cleaning requirements to achieve both dry and
wet use.
2.4 Introduction of the Product
• "
" Mode switching button: When the ma-
chine is turned on, the default water spray is
small, and switching modes are as follows:
Water spraying small lever (vacuum small lever)
-Water spraying big lever (vacuum big lever)
-Water spraying off (vacuum big level)
• "
" On/Off Button: Tilt the product in shutdown
state. Press the power button to start the machine,
and press the On/Off button again to shut down the
machine.
• "
" Self-cleaning Button: After cleaning, place
the machine on the soragestation and press the
Self-cleaning button while charging.
27 / EN