Why Do I Only Hear A High-Pitched Tone; Can I Play My Regular Records When I Am Using Spin; Can I Play My Records At 45 Rpm Instead Of 33 Rpm - Reloop SPIN! Bedienungsanleitung

5.4 Why is there no timecode signal?
If Spin! can not detect a timecode signal during installation please make sure you
do not have a microphone plugged to the interface (the mic input disables
input 1).
If your turntables are connected to the interface and there is no mic plugged in
and Spin! can not read a timecode signal then proceed as follows:
Go to „Options/ Timecode" and check if any waveforms are displayed. If there is
only one waveform displayed then there is a faulty connection between your
needle and the interface. In order for Spin! to work it needs to read TWO
waveforms. Just to clarify: that means TWO waveforms PER PLAYER, shown in
red and white.
First, swap your needles. If the problem migrates along with your needle to the
second turntable then your needle is either dirty/ broken or the contacts are
dirty. Use a q-tip and some cleaning alcohol to clean both the contacts on the
cartridge and in the tonearm. Please do NOT spray contact spray or anything
else into the tonearm!
You can check whether you get a stereo signal out of your turntable by playing
a normal record and using the panorama knob on your mixer.
If both needles work on one of the turntables but not on the second turntable
then you probably have a bad RCA cord. Please replace it. If the audio cords are
permanently attached to your turntable then contact your specialized dealer /
technician and ask for help.

5.5 Why do I only hear a high-pitched tone?

You're listening to the timecode stream because you activated „Vinyl Bypass",
located right above the Label Monitor. „Vinyl Bypass" allows you to play your
normal records. In your case, you're playing the timecode vinyl. Deactivate „Vinyl
Bypass" and the control vinyl will play your digital music.

5.6 Can I play my regular records when I am using Spin!?

Absolutely. Activate „Vinyl Bypass" (right above the Label Monitor). The signal
coming from your records is now made audible. Use the following hotkeys: „N"
will toggle Bypass for the left player, „M" for the right.
5.7 Why is the music playing backwards?
Your turntable is playing normally yet your music is playing backwards? Your
turntable may be hooked up incorrectly.
Your cables are mixed up- the left and right channels of your turntable are
reversed. Simply swap them and everything should be back to normal.
If for some reason you can't swap the cables then go to „File-> Options->
Timecode" and check the box next to „Left/Right Inverse". Basically this has the
same effect as swapping your cables would have, however, it is always a better
to have your equipment connected correctly.

5.8 Can I play my records at 45 RPM instead of 33 RPM?

Yes. Go to „File -> Options -> Timecode" and check the box next to „45 RPM".
Now re-calibrate Spin! (make sure that the turntable's pitch fader is set to „0").
91