Reloop SPIN! Bedienungsanleitung Seite 82

14. Circle Diagram
Alternatively the calibration display can be shown as a circle diagram. To do so
activate this button.
15. Calibrate Test
Push this button in order to calibrate the respective player automatically with
the pre-set options.
16. 1 Turntable Mode
If you wish to use only one turntable you should activate this mode in order to
control both players. Make sure that the same interface input is selected under
"Audio Source" (see item 4).
TIP!
You can choose between the players via the TAB button.
17. More Options
Activate this button in order to fade in the advanced options (noise level / noise
filter and 1 turntable mode)
18. Apply
Push this button in order to apply the adjustments. Then push "OK" in order to
quit the menu.
4.1.5 Workspace
1
2
1. Resolution Selection
The available resolutions are listed here. Select the according resolution for your
monitor.
2. Apply
Adopt the settings via the apply button.
82