Inhaltsverzeichnis
Werbung
Allgemeiner Teil / General Section
SPECIAL SETTINGS
Changing the communication channel of the HiFi
and the loudspeakers
AUDIO CHANNEL
CHANNEL: 3
ROOM 1: RF
BACK
LINK
+
-
Switching the HiFi system to Vertical mode
HORIZONTAL
VERTIKAL
SPECIAL SETTINGS
Switching the loudspeakers in Room 1 to Cable
mode
AUDIO CHANNEL
CHANNEL: 3
ROOM 1: RF
BACK
LINK
+
-
AUDIO CHANNEL
CHANNEL: 3
ROOM 1: LINE
BACK
LINK
+
-
1 - 16
____________________________________________________________________
If interference occurs during sound transmission, which can happen if another
device is using the same frequency, you can change the communication chan-
nel.
Seven channels are available. When you first set up the system Channel 1 is sel-
ected by default.
1
Switch on the HiFi and the loudspeakers in Room 1 only.
2
Press the »CONTROL« button on the remote control.
3
From the »
« menu, select the »
CONTROL
pressing »A« or »S« and then »OK« to confirm.
– The selected channel appears in the remote control display.
4
Select the new channel (from 2 to 7) by pressing »
1
Switch off the HiFi by pressing the
»O
2
Press
»VOLUME
+« on the HiFi and keep it pressed while you switch the
HiFi on again with the
»O
I« button.
HORIZONTAL
– The HiFi display reads: »
3
Press
»VOLUME
+« on the HiFi to switch the system to Vertical operating
mode.
VERTIKAL
– The HiFi display reads: »
«.
4
Confirm the setting by pressing »
« on the HiFi.
4
5
Press the »OPEN/CLOSE« button on the HiFi to open the CD compartment
and then close it again.
____________________________________________________________________
This option is available in case you do not want to use radio signals for the loud-
speakers in Room 1, but rather to connect them to the HiFi using LF cables.
Note:
Before you implement this setting the loudspeakers must first be connected to
the HiFi using cinch cables and installed (see Page 16).
1
Switch on the HiFi and all the loudspeakers.
2
Press the »CONTROL« button on the remote control.
3
From the »
« menu, select the »
CONTROL
pressing »A« or »S« and then »OK« to confirm.
– Display: »
«.
ROOM 1: RF
4
Select »LINK« to switch the loudspeakers to Cable mode.
– The display changes to »
ROOM 1: LINE
Note:
If you change the loudspeakers back to wireless operation, repeat the set-
ting. The display changes back to »
ROOM 1: RF
« item by
AUDIO CHANNEL
« or » +«.
–
I« button.
«.
« item by
AUDIO CHANNEL
«.
«
RCD 2000
GRUNDIG Service
Werbung
Inhaltsverzeichnis
