Inhaltsverzeichnis
Werbung
RCD 2000
CONNECTION AND PREPARATION
INSTALL
INSTALL
ALL SETS ON
RCD
INSTALL
ALL SETS ON
RCD LS1
INSTALL
ALL SETS ON
RCD LS1 LS2
INSTALL
SELECT LEFT LS
AND PRESS OK
CONNECTION AND PREPARATION
INSTALL
CONFIRM RIGHT LS
WITH OK
INSTALL
READY
TUNER
87.50 MHz
MENU
INFO
MEMO
GRUNDIG Service
HORIZONTAL
4
Confirm the »
« setting by pressing the »
HiFi.
INSTALL
– The HiFi display reads: »
«.
5
Insert the three batteries supplied into the remote control battery compart-
ment, making sure the polarity is correct.
– When you insert the batteries the remote control display reads
»
INSTALL
ALL SETS ON
trol has detected the HiFi system.
6
Switch on the left loudspeaker of the first pair using the
– The orange indicator in the
»POWER
control display reads: »
RCD LS1
«. The remote control and the HiFi have
detected the left loudspeaker.
7
Switch on the right loudspeaker of the first pair using the
ton.
– The orange indicator in the
»POWER
control display reads: »
RCD LS1 LS 2
HiFi have detected the right loudspeaker.
Hint:
If you do not see the message »
ALL SETS ON
must reset the HiFi to its original state – see the "INFORMATION" section on
Page 56. Then repeat the set-up procedure from Step 1.
8
Press »OK« to confirm the setting.
– The remote control display reads: »
«, the orange indicator in the
OK
speaker flashes and the orange indicator in the
right loudspeaker lights up continuously.
Note:
If you want to use the left loudspeaker as a right loudspeaker, press »+«
once. The orange indicator in the
»POWER
speaker flashes.
9
Press »OK« to confirm the setting.
– The remote control display reads: »
the orange indicator in the
»POWER
lights up continuously and the orange indicator in the
on the right loudspeaker flashes.
10
Press »OK« to confirm the setting.
– The remote control display reads: »
»POWER
« buttons on the loudspeakers light continuously.
11
Press »OK« to confirm the setting.
– The remote control display reads: »
– Both loudspeakers are switched on automatically and the green indicators
in the
»POWER
« buttons light up continuously.
Note:
If the loudspeakers are not switched on automatically, switch them on
manually by pressing
»VOLUME
x
x
_______________________________________
« button on the
4
«, indicating that the remote con-
RCD
»POWER
« button.
« button lights up and the remote
»POWER
« but-
« button lights up and the remote
«. The remote control and the
«, you
RCD LS1 LS 2
SELECT LEFT LS AND PRESS
»POWER
« button on the left loud-
»POWER
« button on the
« button on the right loud-
_______________________________________
«,
CONFIRM RIGHT LS WITH OK
« button on the left loudspeaker
»POWER
« button
«, the orange indicators in both
READY
«.
TUNER 87.50 MHz
«.
Allgemeiner Teil / General Section
1 - 15
Werbung
Inhaltsverzeichnis
