AEG Electrolux L 56840 Benutzerinformation Seite 25

Problem
The machine does not empty and/or does not
spin:
There is water on the floor:
Unsatisfactory washing results:
Possible cause/Solution
The drain hose is squashed or kinked. (Yellow
pilot light of button 5 blinks)
• Check the drain hose connection.
The drain filter is clogged. (Yellow pilot light of
button 5 blinks)
• Clean the drain filter.
An option or a programme that ends with the
water still in the tub or a that eliminates all the
spinning phases has been selected.
• Select the draining or spinning programme.
The laundry is not evenly distributed in the
drum.
• Redistribute the laundry.
• The laundry load is perhaps to little, add more
items, redistribute the load manually and
then select the spinning programme.
Too much detergent or unsuitable detergent
(creates too much foam) has been used.
• Reduce the detergent quantity or use another
one.
Check whether there are any leaks from one of
the inlet hose fittings. It is not always easy to
see this as the water runs down the hose; check
to see if it is damp.
• Check the water inlet hose connection.
The drain or the inlet hose is damaged.
• Replace it with a new one.
The cap on the emergency emptying hose has
not been replaced or the filter has not been
properly screwed in after cleaning action.
• Refit the cap on the emergency emptying
hose or screw the filter fully in.
Too little detergent or unsuitable detergent has
been used.
• Increase the detergent quantity or use anoth-
er one.
Stubborn stains have not been treated prior to
washing.
• Use commercial products to treat the stub-
born stains.
The correct temperature was not selected.
• Check if you have selected the correct tem-
perature.
Excessive laundry load.
• Introduce into the drum less laundry.
25
What to do if...