Inhaltsverzeichnis; Introduction - Auto Logo Insert - Sony DSR-PD150 Bedienungsanleitung

Introduction - Auto Logo Insert

The auto logo insert function is designed for copyright protection. Using this function, a
registered still image is always inserted on a moving picture to assure copyright
protection.
Once you set the auto logo insert function to active:
•You can insert a still image recorded in a "Memory Stick" onto a moving picture.
•You cannot shoot if you remove the "Memory Stick" that the registered logo file is
stored in.
•You need your password to deactivate this function.
You can secure a copyright of a picture shot by your camcorder on the functions above.
Do not forget your password!
If you forget your password, the memory of the camcorder must be formatted. There
is a charge for it even if your camcorder is still under guarantee.
Do not remove the battery pack, the AC Adaptor, or the "Memory Stick" while
registering the logo!
Otherwise, the "Memory Stick," image data, or setting information on the LOGO
INS item may be damaged, and moreover, this will cause serious damage of the
camcorder.
The following functions do not work when the auto logo insert function is active:
- Progressive mode (DSR-PD150/PD150P/250/250P)
- Progressive recording mode (DSR-PD170/PD170P)
- Memory mix
- All the functions in memory mode
- Even though you set the POWER switch to MEMORY, the camcorder works in
CAMERA mode (DSR-PD150/PD150P/PD170/PD170P)
- Even though you set the MEMORY/CAMERA/VTR selector to MEMORY, the
camcorder works in CAMERA mode (DSR-250/250P)
- All the functions that are used with the "Memory Stick" in VCR mode (DSR-PD150/
PD150P/PD170/PD170P) or in VTR mode (DSR-250/250P)
The DSR-PD170/PD170P is the model used for illustration purposes. Any differences in
operation are clearly indicated in the text, for example, "DSR-PD170/PD170P only."
Table of contents
Introduction - Auto Logo Insert .............................................................................................. 2
Preparing a logo file ................................................................................................................... 3
Registering your password ....................................................................................................... 4
Registering a still image to be used as a logo ......................................................................... 6
Deactivating the auto logo insert function ........................................................................... 10
Changing or resetting the setup ............................................................................................. 11
Precautions concerning the auto logo insert function ......................................................... 13
2
Before using this function