Replacing The Battery - HomeMatic HM-Sec-TIS Montageanleitung Und Bedienungsanleitung

4. Perform the teach-in procedure as per Subsec-
tion 6.3 and, if necessary, adjust the inclination
sensor as per Subsection 6.1.
5. Attach the housing cover to the device in such
a way that the recessed cut-out for the device
LED is at the top and the LED can be seen
through it.
Ensure that the neoprene cover seal is clean,
that it is properly seated in the groove all the
way around the cover (the joint must be at the
bottom when the device is in use) and that it is
not pinched at any point.
6. Use the two cover screws to screw the cover on.

6.2.1 Replacing the battery

Caution! There will be a risk of explosion if
the battery is not replaced correctly. Observe
the notes in Subsection 6.2.
If the equipment being controlled does not respond
when the device inclines and there is no remediable
Used batteries should not be dis-
posed of with regular domestic waste.
Instead, take them to your local bat-
tery disposal point.
25