Troubleshooting; Digital-Display - Zipper ZI-STE2800 Originalbetriebsanleitung

18

TROUBLESHOOTING

Disconnect the machine from the power supply prior to any checks performed at the
machine itself !
Trouble
The engine
doesn't start
Engine is difficult
to start or runs
bad
Motor is too hot
Motor too little
power
No power from
the power out-
lets
Low output vol-
tage under load
Uneven Output
voltage
Digital display
"P-25"
Digital display
"P-50"
Digital display
"P-100"
Z.I.P.P.E.R MASCHINEN GmbH  www.Zipper-maschinen.at
Stromerzeuger / Generator ZI-STE2800
Reason
 No fuel
 Turn engine switch to ON
 Reversing defective
 Check oil level
 Spark plugs contact Candle
 Air filter clogged
 Fuel tap clogged
 Faulty motor
 Too rich fuel mixture
 Carburetor incorrectly
 Faulty spark plug, dirty or misa-
ligned
 Too little engine oil
 Cold air system restricted
 Dirty air filter
 Carburetor not adjusted properly
 Dirty air filter
 Breaker is in position "OFF"
 Engine speed is too low
 Too much load available
 Unbalanced load available
 P-25: Request to first oil change
when a new device after 25 operat-
ing hours
 P-50: Request to Change oil and
clean the air filter every 50 operat-
ing hours
 P-100: Request for cleaning the fuel
and air filter and oil change every
100 operating hours
ZI-STE8000 / 8004
 Filling the fuel tank
 switch to ON
 repair recoil
 add oil
 OIL LEVEL CONTROL!
 Check for real game 16.2.3
 See Maintenance 16.2.2
 refer to Maintenance
 refer to Maintenance
 Contact the retailer
 Set choke to OPEN position
 Can make settings by autho-
rized personnel
 Clean the spark plug, New Ad-
just or replace
 Engine oil
 Clean fan guard, internal
 Clean the cooling fins
 Clean the air filter
 Let carburetor adjusted by au-
thorized specialist
 Clean the filter elements, possi-
bly exchange
 Breaker to position "ON"
 Let engine speed of an autho-
rized service set
 Reduce Existing Load
 Total load away. Then apply
again individually to determine
what causes the uneven loads
the function.
 Change Engine Oil
 Change the engine oil
 Clean the air filter
 Clean the fuel filter
 Clean the air filter
 Change the engine oil.
ZI-STE11000
TROUBLESHOOTING
Shooting
Seite 44