SOLIS 698 Bedienungsanleitung Seite 35

T IP O VER P ROT ECT ION
■ ■
• Should the appliance be tipped over, the appliance will immediately switch to
standby mode resp. stop the blower after 10 seconds. This is done for your
safety, as a tipped over heater can cause a fire.
SW I TCHI N G TH E AP P LIA NCE O FF
■ ■
1. If you want to switch the appliance off, press the
and wait for the appliance to count down from 10 to 0. Then, the blower will
stop as well.
2. As soon as the numbers in the display have gone out, push the power tilt switch
on the appliance back side to the position „0" and pull the plug.
CAUTION: If you want to operate your appliance with a smartphone, your appli­
ance has to be plugged in and switched on with the power switch (power tilt
switch set to position „I") so that it is in standby mode. Furthermore, it has to be
connected to the WiFi.
WI F I FUNC TI ON : OP E RAT E Y O U R WI FI C E R A MI C H E A T E R
■ ■
BY SMART PHO NE
• If you have installed the free app on your smartphone, this modern ceramic
heater can by very easily operated and controlled with your smartphone from
everywhere (from the same WiFi network, from a different WiFi network or
from the 3G resp. 4G mobile data network). Everything you need for that are
the heater, a WiFi router, your smartphone and, obviously, the app.
Step 1: Downloading the free app
1. Should you own an iPhone, get the app
„Solis Heater" from the App Store.
2. Should you own an Android phone, get the
app „Solis Heater" from the Google Play
Store.
3. Go to the „Search" function and type
„Solis Heater" into the search bar. After that,
you can download the app.
68
;
button on the control panel
Step 2: Connecting WiFi router and heater (to connect, the smartphone and the
heater have to be logged on to the same WiFi network)
1. Check if the heater is connected to the power (connect power plug to wall
outlet) and switched on with the power tilt switch on the appliance backside,
so that it is in standby mode.
2. Open the app.
3. Switch the heater on with the ON / OFF button
on the appliance backside pressed until the
panel.
4. Then, click „Add a new device" in the app (fig. 1). The detected WiFi network
is displayed (fig. 2).
5. Enter the corresponding WiFi password of the router and then press the arrow
symbol (fig. 2). Wait approx. 120 seconds (you can watch the time being count­
ed down on your smartphone).
6. The user interface appears on your mobile phone. You can now comfortably
operate your ceramic heater with your smartphone (fig. 3)
fig. 1 fig. 2
TIP: You can rename the appliance by touching and holding the appliance name in
the menu shown in fig. 1.
CAUTION: To permanently operate the appliance with your smartphone, it
has to be connected to the power and the power switch on the appliance
backside has to be set to the position „I", so that your appliance is in stand-
by mode. This allows it to be switched on and be programmed at any time.
NOTE: If you want to connect to a new WiFi network, press the WiFi button on
the appliance back side of the heater until the
previously mentioned steps.
;
and keep the WiFi button
symbol flickers in the control
fig.3
symbol flickers and repeat all
69