Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
S TA RTIN G U P
s
•
Place the appliance upright on a dry and stable surface near a power socket.
Place the appliance in such a way that it can not be knocked over and nobody
trips over the power cord.
•
Plug the power plug into a suitable wall outlet.
SW I TCHI N G TH E AP P LIA NCE O N
■
■
1. Set the power flip switch on the appliance back side to „I". A signal sound
can be heard twice and the symbol
the appliance is now in standby mode. You can now activate the appliance by
;
pressing the ON / OFF button
in the control panel.
CAUTION: When in standby mode, the heater will only react if you press the
;
button. All other buttons are operable only after the appliance has been activated
;
with the
button.
NOTE: To turn the appliance off again, press the
will count down from 10 to 0, then the appliance is switched off and returned to
standby mode.
2. Once the appliance has been switched on, the
ing power as well as the current room temperature with the symbol „°C" to its
right side light up.
A D JUS TI NG H EA T IN G PO WE R
■
■
1. With the
button, you can adjust heating power.
2. Low heating power is the standard setting after activation. If you press the
button, the appliance will work on high heating power. Pressing the button
again will switch back to low heating power. The control panel will always dis
play the corresponding symbol:
low heating power
high heating power
CAUTION: In ECO mode you can not adjust heating power, here, the heating
power automatically adapts to the current room temperature.
64
;
lights up in the display to indicate that
;
button once more. The display
symbol indicating low heat
A DJU S TI NG TI M E R (OP ER ATI NG T IM E )
■
■
1. You can adjust the timer and thus determine how long the appliance should
heat before automatically switching off with the MODE button
button once. The figure „0" flashes in the display next to „H",
2. Press the
representing hours. Press the
the
button to decrease the number of hours. You can set any operating
time between 0 and 12 hours. Each press of the
change the setting by one hour. Keep the buttons pressed for 2 seconds or
longer and the display will quickly count up or down.
3. Not pressing either of the two buttons for 5 seconds or pressing any other but
ton saves the setting. The display states the remaining operating time in hours
and the heater automatically switches to standby mode once it reaches „0"
NOTES:
•
You can only adjust the timer by pressing the
lights up in the control panel and then using the
the time. Only pressing the
button without using the
tons afterwards will not set an operating time and does not activate the timer.
•
If you do not wish to set an operating time (setting „0" hours), your appliance
will stay active until it is manually switched off with the
S E T T ING TH E D ES I R E D TE M PE R A TUR E
■
■
1. You can use the
button to set the desired room temperature.
2. Press the
button twice. The number flashes in the display, next to „°C"
representing degrees Celsius.
3. Press the
button to increase temperature or the
temperature. You can set any room temperature you desire, between 5 °C
and 35 °C. Each press of the buttons
one degree. Keep the buttons pressed for longer than 2 seconds and the display
will quickly count up or down.
4. Not pressing either of the two buttons for 5 seconds or pressing any other
button saves the setting.
.
button to increase the number of hours or
and
buttons will
button once so that „H"
and
buttons to set
or
;
button.
button to decrease
or
changes the setting by
but
65
Werbung
Inhaltsverzeichnis
