SOLIS 698 Bedienungsanleitung Seite 34

NOTES:
• You can only set your desired temperature by pressing the
that „°C" lights up in the control panel and then using the
tons to set the temperature. Only pressing the
the or buttons afterwards will not set any temperature. Instead, the
last set temperature stays saved.
• If you have selected the automatic ECO mode, you can not set a desired tem­
perature. The standard setting in ECO mode is 22 °C and can not be changed.
In general:
• The built­in thermostat takes approx. 10 seconds to register the current room
temperature. As soon as it has registered the room temperature, the ceramic
heater starts up, provided the current room temperature is at least 2 °C lower
than the set temperature. If the current room temperature is at least 2 °C higher
than the set temperature, heating stops and the symbols for low or high heating
power in the control panel go out. When the temperature sinks again,
the appliance automatically switches back on.
• Please consider that the thermostat in the appliance can only measure the tem­
perature immediately surrounding the appliance. Should you simultaneously
measure the temperature with a thermometer some distance away from the
heater (f.e. in the other end of the room), the value measured by the thermome­
ter could be a few degrees lower than the value displayed by the heater. Should
the thermometer be positioned f.e. directly above the heater, the value could
be even higher than stated on the heater, as warm air rises up. The heating
function of the WiFi Ceramic Heater is determined by the temperature value
measured and displayed by the built­in thermostat of the heater.
• If you have set the timer, the set operation time and the current room temper­
ature alternately light up at 30 second intervals. If you have not set the timer,
the current room temperature is displayed constantly.
66
button twice so
and but­
button twice without using
S ET T I NG TH E AU TOM AT IC EC O M ODE
■ ■
• When you press the ECO mode button, you switch to the energy saving and
automatic ECO mode. The display states ECO.
• In ECO mode, the set room temperature is fixed to 22 °C, it can not be changed.
• If the current room temperature is below 18 °C, the appliance works at high
heating power in ECO mode. The corresponding symbol
control panel.
• If the current room temperature is between 18 °C and 22 °C, the appliance
works at low heating power in ECO mode. The corresponding symbol
up in the control panel.
• Once the room temperature has reached 22 °C, the appliance switches to stand­
by mode. The display constantly shows the current room temperature.
NOTES:
• In ECO mode, neither the heating power nor the desired room temperature
can be set.
• You can, however, set the timer in ECO mode to determine operating time.
ME MOR Y FUN C TI ON
■ ■
• If you have not disconnected the appliance from the power grid and/or switched
it off with the power flip switch and then switch it on again with the
without making any other settings, the appliance works in the last saved set­
tings. Only the timer function is not saved, meaning operation time is not set.
• If the appliance was disconnected from the power grid or switched off with the
power flip switch, the last saved settings are deleted. The appliance will start
in low heating power with a standard temperature setting of 25 °C once it is
reactivated.
F OR Y OUR I NF OR M AT IO N
■ ■
• After approx. 1 minute, the illumination of the function lights in the control
panel and the display is dimmed resp. reduced by one third. This prevents the
lights from affecting your sleep at night. Each time the appliance is operated
and the buttons are pressed, the LED lamps light up in the highest brightness.
lights up in the
lights
;
button
67