Pioneer DJM-T1 Bedienungsanleitung Seite 20

! First turn off [Generic Controller Mode] in this unit's settings. For details, see
Changing this unit's settings on page 27.
! The following section describes the procedure for operating the LFO CONTROL
function in the [Group] mode.
1 Turn an effect control dial while pressing the [SHIFT]
button.
This selects the type of effect.
2 Press an effect control button while pressing the [SHIFT]
button.
The LFO CONTROL function turns on.
If the effect is off, it turns on simultaneously.
! When the same button is pressed again, the LFO CONTROL function turns off
and the effect turns back on.
3 Turn the effect control dial.
Adjusts the cycle for changing the degree of each effects.
4 Turn the [DRY/WET] control.
Adjust the balance between the effect sound for all of the effects together and the
original sound.
20
En