Brakes; Change Of Battery; Transport Setting Of Damping, Counterbalance And Brakes - Sachtler Cine 7 + 7 HD Benutzerhandbuch

Cine 7 + 7 HD
of fluid damping is selected. Turn the setting ring to "0" in
order to switch off the damping completely.
The different damping levels can only be felt if the horizon-
tal and vertical brakes are open. If you apply damping, the
degree of horizontal and vertical damping is identical and-
thus enables precise diagonal panning movements without
jerks and vibrations.
Make sure that you always turn the setting to the next
indexed position (arrow pointing on index dot). Engage the
retainer pins by slowly panning or tilting the camera.
ATTENTION: Panning or tilting the camera with settings
between the indexed positions can damage the retainer
pins and/or disks.

3.7 Brakes

The horizontal brake applies the lock for the pan and the
vertical brake for the tilt movement. Both brakes are free
off vibrations and can be used during shooting.
3.8 Change of the battery
The illumination is powered by one standard type button
cell (CR 2032, 3 V) located in the battery holder, which can
be opened with a sharp object such as a screwdriver.
Make sure to insert the new batteries according to the
"plus" symbol as indicated in the covering plate.
The battery last for about 2000 illumination cycles.
3.9 Transport setting of damping, counterbalance
and brakes
To ensure smooth operation of the setting rings for the
damping over the long life time period of the fluid head,
you should turn both setting rings from position "0" to maxi-
mum position, before and after the use of the fluid head.
Setting during transportation: the most important issue is to
open both brakes - horizontal and vertical. Counterbalance
and damping should be set to maximum position.
- 9 -
Manual