Sharp XV-Z12000 Anleitung Seite 10

XV-Z12000
Projector (Rear View)
INPUT 1 terminals
Terminals for
component and
RGB signals .
INPUT 5 terminal
Terminal for DVI
digital, computer
RGB and component
INPUT 2 terminals
Terminals for
component and RGB
Kensington Security
Standar d connector
Exhaust vent
Remote control
Using the Kensington Lock
This projector has a Kensington Security Standard connector for use with a Kensington MicroSaver Security Sys-
tem. Refer to the information that came with the system for instructions on how to use it to secure the projector. r r
Using the Terminal T T
When the projector is used on a desktop, high mounted or
ceiling mounted, attach the terminal cover (supplied) to hide
the connecting cables.
Attaching the Terminal
1 Align the hook on the terminal cover with the insert hole
in the hook at the back of the projector.
2 Press the hook in the direction indicated with the arrow to
fasten the terminal cover to the projector.
3 Insert the terminal cover into the mounting groove on the
projector while pushing the tabs inside the terminal cover
to the outside with your fingers.
signals.
signals .
AC soc ket
Intake vent
sensor
Cover
T T Cover
Rubber cap
The terminal cover can be attached
after removing the rubber cap.
1
1
Removing the rubber cap attached on the pro-
jector and attach the clips.
10
INPUT 3 terminal
Terminal for
connecting video
equipment with an
S-video terminal.
RS-232C terminal
For controlling
projector using a
computer.
DC 12V OUTPUT
terminal
WIRED REMOTE
cont ro l input
terminal
INPUT 4 terminal
For connecting
video equipment.
Intake vent
3
3
2