High Temperature Alarm - Electrolux GT223 Benutzerinformation

54 www.electrolux.com
3.2 Switching on
1. Insert the plug into the wall socket.
2. Turn the Temperature regulator
clockwise to a medium setting.
The power indicator light will light up.
If the temperature inside the
appliance is too high the
Alarm light will blink. Active
the ActionFreeze function.
3.3 Switching off
Turn the Temperature regulator to the OFF
position.
3.4 Temperature regulation
The temperature within the appliance is
controlled by the Temperature Regulator
situated on the control panel.
To operate the appliance, proceed as
follows:
• to obtain the minimum coldness, turn
the Temperature regulator towards
• to obtain the maximum coldness, turn
the Temperature regulator towards
A medium setting is generally
the most suitable.
However, the exact setting
should be chosen keeping in
mind that the temperature
inside the appliance depends
on:
• room temperature
• how often the lid is
• the quantity of food stored
• the location of the
opened
appliance.

3.5 High temperature alarm

An increase in the temperature in the
freezer (for example due to an power
failure) is indicated by:
• switching on of the Alarm light
• sounding of buzzer
During the alarm phase, the buzzer can be
switched off by pressing the Alarm reset
switch.
During the alarm phase, don't place food
inside the freezer.
When normal conditions are restored the
Alarm light will switch off automatically.
3.6 ActionFreeze function
The freezer compartment is suitable for
long term storage of commercially frozen
and deep-frozen food, and for freezing
fresh food.
Place food in the freezer after a pre-
cooling the appliance for 24 hours.
The freezing process takes 24 hours.
During this period do not put other food in
the freezer. The maximum quantity of
foods to freeze in 24 hours is shown on
the serial number plate.
To activate the ActionFreeze function,
press the ActionFreeze switch.
The ActionFreeze light will light up.
This function stops automatically after 52
hours.
.
It is possible to deactivate the function at
any time by pressing ActionFreeze switch.
.
The ActionFreeze light will switch off.