Herunterladen Inhalt Inhalt Diese Seite drucken

Installation / Initial Operation; Montage - Mise En Service - Tunze Nano RO Station 8515 Gebrauchsanleitung

Vorschau ausblenden Andere Handbücher für Nano RO Station 8515:
Inhaltsverzeichnis

Werbung

Installation / start-up of Nano RO Station
The installation expert should use a water tap, which
corresponds to the respective national measures for
the protection of potable water.For this reason an
anti syphon fitting (or backflow prevention fitting) (1)
should be used, which is suitable for the operation
of a washing machine.
If fitted, remove the protective caps at the ends of
the hoses.
Connect the hose coupling (2) to the cold water
hose with ¾" non-return valve.
Lay the black hose (3) to the run-off. The exuded
water has been filtered, dechlorinated, and has a
hardness increased by about 15 per cent.
Lay the blue hose (4) into the pure water tank.
Prior to connection, check whether cold water is
flowing in.
Slowly open the cold water supply, and check
whether all connections of the unit are water tight.
Use the pressure gauge (2) to check whether the
operating pressure is within the „OPERATING"
range of between 2.8 to 6 bar (40 to 85 PSI).
Recommendation: Pour away the first ten litres
produced. Subsequently the water can be used.
Montage - Mise en service RO Station
L'installateur doit utiliser un robinet d'adduction
correspondant aux normes nationales de potabilité.
Il doit aussi utiliser une armature de sécurité anti-
retour (1) indiquée pour l'utilisation des lave-linge.
Si utilisés, retirez les embouts de protection des
tuyaux d'osmoseur.
Branchez le raccord (2) sur le robinet d'eau froide
équipé d'un anti-retour 3/4".
Raccordez le tuyau noir (3) vers l'évacuation d'eau.
Cette eau est filtrée, déchlorée et possède une
dureté augmentée de 15%.
Raccordez le tuyau bleu (4) vers le réservoir d'eau
pure.
Avant la mise en service, vérifiez l'approvisionnement
en eau froide.
Ouvrez lentement l'arrivée d'eau froide et vérifiez si
tous les raccords de l'appareil sont étanches. Sur le
manomètre (5), vérifiez que la pression de travail se
trouve bien dans la zone « OPERATING » de 2,8 à
6 bars (40 à 85 PSI).
Conseil : veuillez ne pas utiliser les dix premiers
litres de production d'eau pure.
35

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis