Herunterladen Inhalt Inhalt Diese Seite drucken

Safety Instructions - Tunze Nano RO Station 8515 Gebrauchsanleitung

Vorschau ausblenden Andere Handbücher für Nano RO Station 8515:
Inhaltsverzeichnis

Werbung

Safety instructions

Mount power supply unit 5012.01 and controller 8555
in dry and well ventilated locations only ! (1)
Do not mount in the vicinity of heat sources (2); ambient
temperature max. 35° Celsius (95° F).
Do not kink the cable (3).
Do not situate magnetic pane cleaners or other magnets
in the vicinity of the sensor, as otherwise functional
failure is possible; keep a distance of at least 20 cm
(7.8 in.).
Prior to initial operation, please check whether the
operating voltage corresponds to the mains voltage
available.
Do not repair a damaged mains cable, but have the
units repaired.
Connect to recommended TUNZE units only.
During the operation, the valve may turn hot (approx.
60° Celsius / 140° F).
Float switches, internal electric components and valves
can cease up, and may cause water damage to the
reverse osmosis units connected. For this reason, do
not operate the RO Water Controller unattended.
Please also observe the safety instructions for the RO
units !
Keep the operating instructions in a safe place.
Sécurité d'utilisation
Positionnez l'alimentation 5012.01 et le Controller
8555 en un endroit sec et bien aéré ! (1)
Ne positionnez pas les appareillages près d'une
source de chaleur (2), température max. +35°C.
Ne pliez pas les câbles (3).
Afin d'évitez tous défauts, n'approchez pas de
sources magnétiques à moins de 20 cm des
capteurs (4).
Avant toute mise en fonction, vérifiez la compatibilité
de l'alimentation avec le réseau électrique.
N'essayez pas de réparer un câble mais renvoyez
l'appareil au Service Réparations.
Ne raccordez RO Controller qu'aux appareillages
TUNZE® conseillés.
Lors de son fonctionnement, l'électrovanne peut
être très chaude (env. 60°C).
Les capteurs, les composants électriques internes
et l'électrovanne peuvent se bloquer et provoquer
un débordement par fonctionnement permanent de
l'osmoseur inverse. Pour cela, ne pas utiliser RO
Water Controller sans surveillance.
Veuillez observer les sécurités d'utilisation des
appareils RO !
Veuillez attentivement consulter le mode d'emploi.
59

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis