Herunterladen Inhalt Inhalt Diese Seite drucken

Kenwood KRC-591 Bedienungsanleitung Seite 30

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Troubleshooting Guide
?
The Touch Sensor Tone doesn't
✔ The preout jack is being used.
☞ The Touch Sensor Tone can't be output from the preout jack.
?
Even though Synchronize Clock is ON, the clock can't be
✔ The received RDS station isn't sending time data.
☞ Receive another RDS station.
?
Even though the vehicle light switch is turned ON, the unit's display
won't
dim.36
✔ The dimmer wire isn't connected.
☞ Connect the dimmer wire correctly.
?
The Dimmer function doesn't work.
✔ The Dimmer wire isn't connected correctly.
☞ Check the Dimmer wire connection.
Tuner source
?
Radio reception is
poor.39
✔ The car antenna is not extended.
☞ Pull the antenna out all the way.
✔ The antenna control wire is not
☞ Connect the wire correctly, referring to the section on
<Connecting Wires to Terminals>.
?
It isn't the set Traffic information sound volume.
✔ The set sound volume is less than the tuner sound volume.
☞ If the tuner sound volume is louder than the set sound volume,the
tuner sound volume is used.
sound.34
adjusted.35
38-1
connected.40
43
Cassette tape source
?
Can't remove
tape.44
✔ The cause is that more than 10 minutes has elapsed since the vehicle
ACC switch was turned OFF.
☞ The tape can only be removed within 10 minutes of the ACC
switch being turned OFF. If more than 10 minutes has elapsed,
turn the ACC switch ON again and press the Eject button.
?
The DPSS, Tape Advance and Music Repeat don't operate
correctly.45
✔ The space between the songs on the tape can't be recognized
because it's too short.
☞ Have at least 4 seconds between songs.
✔ The space between songs can't be recognized because there's too
much noise between
songs.46
☞ Reduce the noise between songs.
?
The blank skip doesn't
work.47
✔ Because noise is too loud, the non-recorded part can't be recognized.
☞ Reduce the noise between songs.
?
Blank Skip functions at places that are
✔ Because the recording level is low, it's recognized as not recorded.
☞ Turn Blank Skip OFF.
— 30 —
recorded.48

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Krc-691Krc-591v

Inhaltsverzeichnis