Connection With The Mains; Operation - EuroLite LED PSI-1 Bedienungsanleitung

Connection with the mains

The electric connection must only be carried out by a qualified electrician!
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.

OPERATION

After connecting the device to the mains, the LED PSI-1 DMX starts running. This unit has two operating
modes. It can be run DMX-controlled or as a Stand Alone-unit. In the Stand Alone mode, the LED PSI-1
DMX can be used without controller.
Start your LED PSI-1 DMX. "WELCOME TO USE" appears on the LC-display and the unit is carrying out a
self-test.
Navigate through the menu
Press MODE to navigate through the 6 points of the main menu of the LED PSI-1 DMX.
1. LIGHT QTY - Luminaire quantity
LIGHT QTY:
01
MODE SET UP UP DOWN
2. 01- 14 - Internal programs
01.STATIC COLOR
COL:red FS:000
MODE SET UP UP DOWN
3. AUTO RUN - Automatic Color-Change
AUTO RUN
FREQUENCY: 001
MODE SET UP UP DOWN
DANGER TO LIFE!
International
L
N
Under this point of the menu, you can define the number of LED luminaries
connected to the LED PSI-1 DMX. For an ideal performance, always connect an
even number of LED luminaries (4,6,8,10,12) to this controller.
Under this point of the menu, you can select one of 14 internal programs (chasers).
A chaser is a sequence of different steps that will be called up one after another in a
continuos loop. The chaser speed (SP) and the strobe speed (FS) is also adjustable.
Use the button SET UP to jump from input value to input value and define the values
with buttons UP/DOWN.
With this point of the menu, you can activate the automatic color-change. In Auto
Mode the chasers are called up automatically in a continuous loop. The frequency of
the loops can be defined via buttons UP/DOWN between 001 and 100.
25/29 00027825.DOC, Version 1.1