Dmx512 Control; Addressing The Device - EuroLite LED PSI-1 Bedienungsanleitung

Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a balanced microphone lead.
Connect the DMX OUT-jack with the DMX IN-plug of the next device.
DMX-512 control
The wires must not come into contact with each other, otherwise
Please note, the starting address depends upon which controller is being used.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the device or one device with another.
Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first device in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first device in the DMX-chain with the DMX-input of the next device. Always
connect one output with the input of the next device until all devices are connected.
Caution: At the last device, the DMX-cable has to be terminated with a terminator. Solder a 120
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last device.

Addressing the device

The control board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED PSI-1 DMX will respond to the lighting controller.
DMX MODE
DMX address: 001
MODE SET UP UP DOWN
Controlling:
After having addressed the LED PSI-1 DMX, you may now start operating it via your lighting controller.
the devices will not work at all, or will not work properly.
To define the starting address, you have to be in DMX-mode. Press MODE until
the display indicates d001. In DMX-mode, the DMX LED indicator lights up.
Set an address between 001 and 512 via the UP and DOWN buttons.
24/29
resistor
00027825.DOC, Version 1.1