Installation; Wall Mounting - EuroLite LED PSI-1 Bedienungsanleitung

Connections
DMX OUT DMX IN
6 7
6. DMX OUTPUT SOCKET
7. DMX INPUT SOCKET
8. LOAD OUTPUTS
9. FUSE
10. POWER SUPPLY
11. POWER ON/OFF

INSTALLATION

Install the device on a plane surface or mount it on a wall or trussing system.

Wall mounting

Before attaching the device, make sure that the installation area can hold a minimum point load of 10 times
the device's weight.
The device must only be installed absolutely planar at a vibration-free, oscilation-free and fire-resistant
location. Make sure that the device is installed absolutely planar by using a water-level.
The device must be installed out of the reach of people.
The device must always be installed via all fixation holes. Do only use appropriate screws and make sure
that the screws are properly connected with the ground.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
Procedure:
Step 1: On the baseplate, there are the holes for the installation.
Step 2: Hold the baseplate onto the location where the device is to be installed.
Step 3: Mark the boreholes with a pen or a suitable tool.
Step 4: Drill the holes.
Step 5: Hold the baseplate in the desired position and tighten it.
Before taking into operation for the first time, the installation has to be approved by an expert!
LIGHT 11 LIGHT 9 LIGHT 7
LIGHT 12 LIGHT 10 LIGHT 8
DANGER TO LIFE!
LIGHT 5 LIGHT 3 LIGHT 1
LIGHT 6 LIGHT 4 LIGHT 2
8
21/29
ON
FUSE: F 4 A/230 V POWER IN
AC 100-240 V 50/60 Hz
OFF
9 10 11
00027825.DOC, Version 1.1