EuroLite LED PSI-1 Bedienungsanleitung Seite 23

DANGER TO LIFE!
Before taking into operation for the first time, the installation has to be approved by an expert!
Connection with luminaries
ON
LIGHT 11 LIGHT 9 LIGHT 7 LIGHT 5 LIGHT 3 LIGHT 1 FUSE: F 4 A/230 V POWER IN
AC 100-240 V 50/60 Hz
OFF
DMX OUT DMX IN
LIGHT 12 LIGHT 10 LIGHT 8 LIGHT 6 LIGHT 4 LIGHT 2
100-240 V AC, 50/60 Hz ~
Connect your loads to the 4-pin connection cables at the load outputs of the controller.
Connect the controller to the mains with the power plug. With the POWER-switch, you can switch the
controller on and off.
Attention: The maximum length of the connection cable between load and controller may not exceed 50 m.
Outputs
The output sockets are located on the rear panel. Connect your loads to the connectors. The maximum load
per channel is 27 W. Please note that the maximum current must never be exceeded!
Master/Slave-operation
The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the side panel of the EUROLITE LED PSI-1 DMX you can find an XLR-jack (DMX Out) and an XLR-plug
(DMX In), which can be used for connecting several devices.
23/29 00027825.DOC, Version 1.1