Common Flight; Throttle Curve - Carson bluster250se Bedienungsanleitung

n. Common Flight

Common flight

Throttle curve

5 100% high speed
4 85%
3 65% ~70% hanging
2 40%
1 0% low speed
Warning
When switching from normal to idle 1, (3 D position on the
switch) do not switch the switch unless you have the throttle
set to at least 70% of throttle setting. This will prevent possible
gear damage because when using this switch it increases the
throttle to a higher level. Should you switch the 3D switch,
Joystick high-speed/ throttle curve 100% / Pitch +9° ~+11°
Joystick center position/ hover flight/ throttle curve 65% ~ 70% / Pitch +5° ~+6°
Joystick low-speed/ throttle curve 0% / Pitch 0°
Pitch
+9° ~+11°
+5° ~+6°
0°
CARSON 3D Helicopter Bluster 250se 50 050 7028
Throttle curve on mode of hovering
idle 1 prior to having a high throttle setting it can cause the
helicopter to become unstable and could cause a tip over or
crash. Idle 1, or the 3D switch allows the throttle to have full
power at the bottom and top positions of the throttle stick
travel. With the 3D switch activated you can perform acrobatic
flight, i.e., inverted flying.
GB
19